This earring is a mix of the loops earring and the rhombus earring.
I rotated my working board while working, I hope the steps are clear and you can follow them, if necessary you may watch the images again and it will be more comprehensible! 🙂
You can mirror the pattern to have a left and a right piece of earring, or you can knot two exactly same.
You can find out other pattern in the middle and make loops around it, bravely use your imaginations. 🙂
After finishing the earring I usually adjust it with my hands.
I used 1mm Turkish braided waxed polyester cord thread, if you have any questions about the cords I use, or the board I work on, please visit FAQ first.
You start with the 40cm long cords and I wrote the sizes of the cords on the images.
Used materials:
- 13 x 40cm waxed polyester cord (1mm thick) per earring;
- 2 x 70cm waxed polyester cord (1mm thick) per earring;
- 1 x 80cm waxed polyester cord (1mm thick) per earring;
- 2 pcs earring closures.
You will also need:
- a workboard (mine is a covered swimming board);
- scissors;
- pins;
- and a lighter.
Click on the first thumbnail and you can click the left/right arrows to the previous/next step:
Happy knotting! 🙂